A crawl space changes how a radon problem gets fixed, because there is no concrete slab to draw beneath. The principle is the same; the surface the system works against is different.
Why a crawl space is its own case
In a basement house, the slab is the barrier between soil gas and the rooms above, and a mitigation system keeps the space under that slab at lower pressure than the house. A crawl space with a bare earth or gravel floor has no such barrier. Soil gas enters the crawl space freely, and from there moves up into the house through floor joists, gaps around pipes and ductwork.
So the fix starts by creating the barrier that a basement already has.
Sub-membrane depressurization
A heavy sealed sheet is laid over the crawl space floor, run up the walls and sealed at the seams and edges. A suction pipe is set beneath it and connected to a fan that vents above the roofline — exactly as in a sub-slab system, with the membrane playing the part of the slab.
The materials are the same ones EPA specifies for new construction: a gravel layer to let soil gas move freely, heavy plastic sheeting over it, and a solid PVC vent pipe run up and out [1]. In a retrofit the gravel may already be there or may need adding.
Note what this is not. A membrane laid loose over the ground, or taped rather than sealed, with no pipe and no fan, is a vapour barrier for moisture. It is not a radon system, and it will not reliably reduce a radon level.
Sealing the vents is not the answer
A common instinct is to close the crawl space vents. It does not solve a radon problem, and the general warning from Wisconsin DHS applies here with force: sealing alone has not been shown to reduce radon by a great amount [2], and improper installation of a mitigation approach could cause more radon in the air, or damage to your home [2].
Closing a crawl space up without a working depressurization system can also create a moisture problem where there wasn't one. If anything is sealed, it belongs as part of a designed system, with polyurethane caulk rather than silicone on concrete surfaces [2].
Mixed foundations
Plenty of Fox Valley houses are part basement, part crawl space, sometimes with a slab addition. EPA's guidance notes that a house with more than one foundation type may need more than one suction point [3]. This is the case where a diagnostic visit earns its fee, because a single point serving a footprint it cannot reach is the commonest way a system underperforms.
How the components fit together is on how a radon system works.
What it costs
Crawl space work is the expensive end of radon mitigation, mostly because of the membrane. National guides put crawl space encapsulation at $1,500 to $15,000 if needed (Angi) or $3,000 to $15,000 (HomeGuide) [4, 5], against Wisconsin DHS's $1,000 to $2,000 average for a mitigation system generally [2].
The spread is wide because the jobs are different. A small crawl space needing a membrane and one suction point sits near the bottom; full encapsulation of a large, awkward, wet crawl space sits near the top. The full price picture is on radon mitigation cost.
Afterwards
Test. DHS's expectation of a working sub-slab or sub-membrane system is a level below 2 pCi/L [2], and the only way to know your level is a test [6]. Wisconsin requires no post-installation test, so put it in the contract — EPA's guide lists it among the things a mitigation contract should address [3].
And as everywhere in Wisconsin, the state does not license or certify the people who do this work [7]. Crawl space jobs reward experience more than slab jobs do, so the checks on choosing a radon contractor matter here especially — ask specifically what sub-membrane systems the company has done.
Get a quote
Request a quote and say whether the house is all crawl space or part basement, and whether the crawl space is bare earth, gravel or already lined.
We're a referral service, not a contractor. Wisconsin doesn't license or certify radon contractors, so we pass your request to independent contractors without checking their credentials, a referral is not an endorsement, and they may pay us for referrals.
Sources
- Wisconsin DHS, Radon: Resistant Construction (page last revised Oct 22, 2026). https://www.dhs.wisconsin.gov/radon/radon-resistant-const.htm
- Wisconsin DHS, Radon: Mitigation (fetched Nov 18, 2026). https://www.dhs.wisconsin.gov/radon/reduce-radon.htm
- U.S. EPA, Consumer's Guide to Radon Reduction, EPA 402/K-10/005 (2025 edition, PDF). https://www.epa.gov/sites/default/files/2016-12/documents/2016_consumers_guide_to_radon_reduction.pdf
- Angi, "How Much Does a Radon Mitigation System Cost? [2026 Data]," Mitchell Grant, updated Sep 28, 2026. https://www.angi.com/articles/how-much-does-it-cost-remove-radon-gas.htm
- HomeGuide, "How Much Does a Radon Mitigation System Cost? (2026)," Kristen Cramer, Feb 5, 2026. https://homeguide.com/costs/radon-mitigation-cost
- Wisconsin DHS, Radon Information for Wisconsin (page last revised Oct 21, 2026). https://www.dhs.wisconsin.gov/radon/index.htm
- Wisconsin DHS, Radon: How to find a contractor (page last revised Oct 7, 2026). https://www.dhs.wisconsin.gov/radon/proficiency.htm